atlshaun
Basic User
- City
- Atlanta
- State
- GA
My steering column was BUTCHERED by the PO and I have since bought a Flaming river tilt column to replace it. The column has a 1'-48 spline shaft to connect to my steering shaft. As I am looking at my OE steering shaft, it is in bad shape so I figure I will replace it while I install the new column. My question is this: What size joint would I need at the power steering side of the shaft? 3/4-30? 13/16-36? I have no idea.
My jeep is an '83.
My jeep is an '83.