Axle Wrap Issues

[Skidmark]

I seem to be having a issue with axle wrap. I have a SBC crate motor with 320 HP with a 700r4. It also has a 2.5" lift and 33" tires. When I drive it hard, either taking off or when it shifts into second I get a lot of axle wrap. What are you V8 guys doing to eliminate this without loosing ground clearance?

 

[gpassida]

I seem to be having a issue with axle wrap. I have a SBC crate motor with 320 HP with a 700r4. It also has a 2.5" lift and 33" tires. When I drive it hard, either taking off or when it shifts into second I get a lot of axle wrap. What are you V8 guys doing to eliminate this without loosing ground clearance?

One common solution is to add a traction bar like one of the ones below. My 350 TBI only has about 210 HP but with a 124: crawl ratio and spring over, it had some spring wrap. I have a custom version of below the traction bar design and it helped a lot. I still get some in certain situations but I get off the gas and take another line.

Heavy Duty Antiwrap/Traction Bar Kit

Check out the deal on Heavy Duty Antiwrap/Traction Bar Kit at RuffStuff Specialties

www.ruffstuffspecialties.com

Axle Plates for our TB500 Traction Bar for Rear Axle for Jeep CJ7(1976-86) Jeep Wrangler YJ (1987-95)

Do you already have our TB500 and want to install it onto a new axle? Then the T500 axle plates are just what you need to install the TB500 on a new axle. T500 Axle Plates for sold each. So order 2 per TB500 traction bar. FITS: CJ-7 and YJs (will not fit CJ-5). Welding required.

mountainoffroad.com