Recent content by Srambler83

  1. S

    Upgrading

    Tower210, Well just throwing it around and wondering what ppl think. Would like to have one but also not doing anything extreme. I need to get alighnment this week. But definitely have slack and have done quiet a bit to eliminate steering slack. I might just do the alignment first then see...
  2. S

    Installing steering stabilizer

    thank for the heads up. Will keep looking for the installation bracket hardware.
  3. S

    Do I have a lift?

    1983 Scrambler 4.5" suspension lift 1" BL 35" tires 4.56 gear w/ overdrive
  4. S

    Upgrading

    (y)thanks guys, installed. Now can I add a steering stabilizer to this?
  5. S

    Installing steering stabilizer

    Hey Jeepers, Need you help in installing a steering stabilizer. I recently installed the rugged ridge HD 42mm tie rod and drag link. Question is what bracket kit do i need for this installation and where is the bracket installed. I see on amazon a few kits but not too sure of which one to...
  6. S

    What degree shims do i use with the RE 4.5 lift.

    Have a question with the angle of my rear differential yoke to the drive shaft and was wondering if anyone can tell me degree of shims to use. I recently added the RE 4.5" lift. Here are a few pictures. Any help is greatly appreciated.
  7. S

    Upgrading

    Thank you tower210 👍🏻 And thank you ag4ever
  8. S

    Upgrading

    Tower210 thank you. Do you run a damper with your rugged ridge set up you just installed. Going also with the rugged ridge HD. Can I ask where you purchased it from and do you have and item number? Thank you
  9. S

    Upgrading

    Thank you Fummins so no damper will be used, thanks for clarifying. Do you have a picture that i can look at? Sounds pretty straight forward. - drag link and both ends - tie rod and both ends - adjustment with clamps Like the beefier look, any brand recommendations? Anything else anyone...
  10. S

    Upgrading

    Hi again fellow keepers. Have a question. Currently have a 83 cj8. Upgrading tie rod and drag link, tie rod and drag links ends, adjustments, clamps etc. Do I need a dampener? If so where does it go? Is there a kit where I can purchase all in one? Need your experience on getting back on the...
  11. S

    Suspension lift

    Jammer1, do you have your shocks mounted on the spring plate? I noticed some of you have both the disconnect and the shocks mounted to the spring plate and some have it to the previous suspension shock tab. This is where it had it mounted before adding the RE lift. Your thoughts? Pictures and...
  12. S

    Suspension lift

    Adding the 4.5” rubicon express extreme duty lift kit. Can someone please take a picture of the where you have the bottom of the sway disconnect attached. Would like to see where and how it is attached to the leaf spring plate. Will be looking for guidance from you guys to finish my 1983 cj8.
  13. S

    Suspension lift

    Yes, FL Yes, FLCJ8 it is the new style for the Rubicon Express kit
  14. S

    Suspension lift

    Can anyone tell me where these go? Purchased new Rubicon express lift kit 4.5” extreme duty. Do these go on the spring plate for sway bar disconnect? Any help would be appreciated. Trying to piece this back after guy bailed on me.
Top