Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.
Here is my somewhat weekly update. I modified my DBW pedal this weekend. It took about 3hrs total and was not that hard to do. I cut off the lever, removed the plastic foot pedal and flipped the lever to swing left instead of right. I then took some time getting the angle out correct so my...
I just modified my pedal this weekend. It took about 3hrs total and was not that hard to do. I cut off the lever, removed the plastic foot pedal and flipped the lever to swing left instead of right. I then took some time getting the angle out correct so my foot is in a comfortable position...
I ma doing drive by wire just so I can run a switch panel to operate cruise control. I may never need it but I like running cruise on the highway so why not have it.
I am going to DBW ad will be looking at the mounting option this week. I will more than likely be building a custom bracket to get it position correctly. My pedal comes from a Silverado.
The strap clamp will not be strong enough to handle the twisting force and the transmission just has that torque bar style mount. I think you might need something a bit more robust coming off the bellhousing adapter.
I bought a Wablro pump and will be modifying my stock sender. I will have a write up on here after I do it for reference. I will be getting to that part in another week or two after I finished all the other mechanical work. I need to do another update to the thread this week.
Weekly update on the swap progress. I pulled the motor back and replaced the rear main seal and a few other gaskets. I then got the motor back in and drilled the motor mounts to bolt them to the frame. I got all the front end accessories cleaned up a bit and installed and the power steering...
With only 78,000 on the motor I opted to leave it sealed. I did a compression check and the cylinders were good and there was no visible sign of any leaks. The intake ports were not that bad either but I do plan to install a catch can on this motor.
So I mentioned earlier that the shaft had to be cut to 4.1 or 3.85 inches. I called Advance Adapters yesterday and talked to them about it. I showed them in the directions were it shows both measurements and they admitted that it was missed and will be fixing the directions. The measurement is...
The engine being put in place. The Dana300 will not be installed until I get the reluctor ring installed. Once I get that I can install the Dana and then make sure the shifters line up correctly in the tunnel opening. Then once I know the front end has clearance I can measure for new driveshafts.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.