• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Ignition switch

Overland

Legacy Registered User
City
Bristol
State
Pa
Bud of mine bought an 81 off this board almost two years back. Jeep has been sitting with the rare occasional run around the neighborhood.

A few weeks ago we went to move it to it's new home about a mile away. Battery was dead, we charged it out of the vehicle and when i went to reinstall it the Jeep lurched and ran over my foot when i connected the second cable. Key was in off position.

The key and tumbler assembly feels loose, and i see the rod leading down column to switch. Is this switch adjustable? I'm assuming it's sticking or the rod may be in an incorrect position at times allowing the battery to drain.

Are there better brands to aquire for the switch and key assembly? Thinking we will just swap it all out.
 
jallan, that was my first thought as well. Solenoid and starter were replaced first, should have mentioned that.
 
Have NOS (new old stock) AMC Jeep ignition switch with keys. pm sent
 
The switch typically will have slotted mounting holes, so a quarter inch or so of adjustment.
 
Have NOS (new old stock) AMC Jeep ignition switch with keys. pm sent


Jim, PM'd you my buds email. Please contact him and arrange for payment. Thanks!

Decided we will just replace the switch as well, anyone know a source for an NOS replacement?
 
Back
Top