- City
- Colorado Springs
- State
- CO
So I'm about to where I think its time to do something about my Dana 300. I've been working on the bugs
for the suspension trying to get the rear drive shaft at an acceptable angle/length. I think I finally have the ride
height where I can live with it but I'm still thinking more is needed. Add to it that its leaking pretty good so a reseal
isn't a bad idea. I'd like some of ya'lls thoughts on some of my intentions.
Going to get a HD rear output. Thinking right now the Novak kit:
http://www.novak-adapt.com/catalog/transfer_case_parts/300rx.htm
may be for me. Pricey but short. But not only will it add beef, I should be able to gain a little length at the rear.
Question on this since I need to order drive shafts anyway...Which would be better. A traditional style yoke or a flange? Not sure
which would work better or allow more angle.?.
While I'm at it I think I'd like to twin stick it for real. I have all the shifters etc but need to do the rods. Anyone have a link to a good
how-to for this?
Any thoughts or feed back is much appreciated.
for the suspension trying to get the rear drive shaft at an acceptable angle/length. I think I finally have the ride
height where I can live with it but I'm still thinking more is needed. Add to it that its leaking pretty good so a reseal
isn't a bad idea. I'd like some of ya'lls thoughts on some of my intentions.
Going to get a HD rear output. Thinking right now the Novak kit:
http://www.novak-adapt.com/catalog/transfer_case_parts/300rx.htm
may be for me. Pricey but short. But not only will it add beef, I should be able to gain a little length at the rear.
Question on this since I need to order drive shafts anyway...Which would be better. A traditional style yoke or a flange? Not sure
which would work better or allow more angle.?.
While I'm at it I think I'd like to twin stick it for real. I have all the shifters etc but need to do the rods. Anyone have a link to a good
how-to for this?
Any thoughts or feed back is much appreciated.


) so that may be my route if I can swing the cost.