• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Axles width issues?

barrys

Scrambler Junkie
Lifetime Member
City
East Norriton
State
PA
So I have a brand new, 3 owner Dynatrac front Dana 60 bolt in for a CJ. It is wider than stock, I think 58" wms to wms.

Hoping to get a Currie Rock Jock 60 rear this weekend that is 60" wide(was in a YJ, will need spring pads and shock mounts moved, axles have dual bolt pattern).

What issues will arise from the rear axle being wider than the front axle. I guess I could use some spacers up front to get the track width equal to or just slightly wider depending on the width of the spacers.

Bummer is the front is 4.88 open and the rock jock is 3.55 Detroit locked. At least I have a NOS Detroit locker from an old international dealer ship in my basement.

Thanks for any input.
 
If you get REALLY technical:
Keeping your shocks/springs at stock width and using a wider than stock track width axle would require a slightly higher spring rate/shock pressure to keep factory load and rebound characteristics for suspension.

But since we are not talking about a race car and you are only looking at a couple inches difference:
Unless you are planning to make your rear axle steer in addition to the front axle; you wont have any functional issues. If you use same wheels front and back your rear wheels will stick out a bit further than your fronts, but that is it.
And wheel spacers will fix that, just like you said.

Definitely have to match those gears though. Or, run 31's on the rear axle and 44's on the front.
 
Definitely have to match those gears though. Or, run 31's on the rear axle and 44's on the front.

Yeah, I will make a Jeep version of Quagmire, expect it had 48's and 38's[emoji106] (so did the younger guys think....what is Quagmire?)
 
Back
Top