• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Windshield washer bottle, and separate bracket ?

hdttm

Scrambler Enthusiast
Lifetime Member
City
Ashfield
State
MA
2 questions - not really related.

I'm picking away at some minor stuff - 1 being that I'm looking for a windshield washer bottle and pump. I know I can buy an aftermarket set pretty cheap, but if someone has a setup they are looking to sell - I'd rather buy from a member here. I do have the power lead, and the hose going up to the nozzle on the cowl, so all I need is the hardware to mount on the wheel well.

The 2nd part of the question is - what is the round, clamp bracket in the picture below for? At the top of the pic is the yellow power wire for the washer pump, and the hose to go to the nozzle, but below that is the clamp I can't identify, or remember what it's for.
 

Attachments

  • Bracket.jpg
    Bracket.jpg
    161.6 KB · Views: 19
That's for your charcoal canister. A lot of POs pull it along with many of the vacuum lines thinking they're cleaning up the engine bay, then wonder why the engine doesn't perform as well and their garage stinks of gas.

What engine do you have in there? May not be entirely necessary, but it probably is - along with a bunch of other parts.
 
I think that's where the charcoal canister was on my CJ7. I could be wrong, though.
 
It has the 258 inline 6. I haven't found any cut/blocked off vacuum lines - The garage doesn't stink of gas... well now that I replaced a leaking fuel line, but other than that - what other parts would you think missing?
The charcoal canister does make sense though
 
Carb or fuel injection? There should be a line from either, along with several from both ported and manifold vacuum sources, and a connection back to the tank or rollover valves depending on which tank you have. 20g - no external valves; 15g - external valves tucked under the left rear quarter panel.
 
It is carb 15 gallon tank - The rollover (and the other) valve - there are 2 tucked up in the upper part of the left wheel well - I had them both out - and the lines seem to be good to both - should the 2nd be connecting to the [missing] charcoal canister?
 
should the 2nd be connecting to the [missing] charcoal canister?

You got it. The system is meant to provide vapor pressure relief from the tank and harvest residual vapor from a carb or throttle body after shut down. The vapors condense in the canister, and then are taken back up by the system when the engine is running by the vacuum hoses. The ported vacuum (I think) operates a valve in the canister that only opens while the engine is running. The manifold vacuum (I think) pulls those vapors into the carb/throttle body.
 
That makes sense - I appreciate the info. I can't seem to fine a replacement for the charcoal canister, I'd prefer to hook one up and see if it helps smooth the idle out, which really isn't bad, and I think that would help.
 
I'm picking away at some minor stuff - 1 being that I'm looking for a windshield washer bottle and pump. I know I can buy an aftermarket set pretty cheap, but if someone has a setup they are looking to sell - I'd rather buy from a member here. I do have the power lead, and the hose going up to the nozzle on the cowl, so all I need is the hardware to mount on the wheel well.

Maybe check with Certifiablejeep at his Craigslist posting.
https://nh.craigslist.org/pts/d/amc-jeep-cj-cj5-cj7-cj8/6608809612.html
 
Back
Top