Search results

2 out of 6 of the senders passing through my hands in the past 12mos have done this. A third had the primary lead grounding out on the case surrounding the resistance winding. That really makes buying these things a crap shoot. MTS or Omix or whoever is having them produced should be tarred and...

Use this page to verify your gauge functions: http://www.4x4wire.com/jeep/tech/electrical/gauges/ To save you a click, refer to this image and the settings below: S is the first on the left, where your sender wire attaches. A is in the middle, for the voltage reducer that goes to the water...

I went with the ebay in hopes it'd get here soonish; mine isn't even leaking but I figured I may as well now that I have the tank dropped, again! I hate having a full gas tank sitting on the garage floor for any longer than needed, even if all the ports are plugged. My in-tank pump was...

I have been going through this way too frequently over the past few months, right now as a matter of fact. What it sounds like is your float has a hole in it. When you fill up, there's just enough air to make it float - gauge reads full. Over the next few minutes, it fills with gas and sinks to...

You can get one from the DeLorean company, yes that DeLorean. Direct replacement.

Well, better to find out now.

Wait til you see which side the steering wheel is on!

If it's the one I hijacked @tower210 's post with, it can only do Bluetooth on its own. If you have unlimited data, iheartradio or tunein radio are am/fm options, but you'll need a phone.

I mounted mine in the glove box - cut a 1" hole with a hole cutting bit to run the wires. I made my speaker box out of fiberglass this winter, but I don't have an installed photo. It sits right behind the center console and seats, painted it nutmeg to match the console. And I believe my spare...

https://www.amazon.com/Kenwood-1177524-Automotive-Amplifier-Kac-M1824BT/dp/B00UTXQL74 Here's what I have, and I forgot I even have an unused spare that I'd sell for cheap. Doesn't have the OEM harness, just an aftermarket harness with 12" wires, uncut. The OEM harness was like 6'. Everything...

She sure is beautiful.

I know they can, because the builder would routinely send all of his gauges there. The question is whether they can do it in a reasonable time frame. Going on about 10 days now, and when I called I got the "it's on his desk now" line. Hopefully sometime this week. I think these things are...

I thought you may have, it sorta looks like there's a rear drop in the photo.

I wrapped my pipes, and the lines near them. I've been checking and temps are doing pretty well luckily. It is a little hard to reach over the pipes to adjust, but I figure I only have to dial it in once. Not sure I follow. It's a C6 manifold with the O2 sensor in its factory location. What...

If I see the CEL again I just might. The ones I've been using are the duralast/delphi refurbs. The sensitive part is the metal ring on the filter-facing side, which I think is getting the air temp. The Wilwood is really nice. I like being able to dial in the rear brakes to get the feel...

Every time, and you can adjust/skip/pause, etc. with either phone or the cabled remote.

A couple of weeks ago, my fuel gauge pinned and started smoking, so I did what any reasonable Jeeper would do and decided to swap out my valve covers and replace my brake system :crazy: My proportioning valve had a leak from the rear and I still hadn't narrowed down my check engine light...

When I was a kid in upstate NY, my dad and I would get 6-8 cords of wood about this time each year - he'd run the chainsaw and I'd spend an hour or two after school splitting them. (by hand!) After I moved off for school, he continued on his own, cutting and splitting until last summer when he...

I really like my Kenwood BT amp - it fits in the glove box, 50w/channel, and swaps between BT and primary.

I've only had it on pavement, but it'll leave some stains in your drawers if you're not careful.