Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.
Good luck with the change, If you love flipping the jeep parts-jeeps now's your chance to do what you love doing. With any luck this year will work out for you and us all.:cheers:
Barrys your correct. I'm guessing it's oxidation. Try soldering it to new wire. Without flux it doesn't get a good bond (cold solder joint). One of the reasons I go with a new wiring harness vs reusing old harness (not to mention where old wire connects to plugs). If you are doing a...
Thanks, I figured they had a opening toward the top that the oil would be directed to, to get oil to the outer bearing. Didn't expect it to be large enough for the tooth to fit in. Maybe someone upstairs is looking out for the jeep. Where it was sitting it's less likely to do damage than...
:fingerscrossed: May you have better luck with fuel injection than I've had on my 2 work trucks. When it works it's nice. If it develops a problem that's intermittent and the mechanics can't track down it's enough to pull your hair out (unfortunately I don't have enough to pull out).:rotfl:
Only real problem was the drag link tie rod. Couldn't get it loose with a pickle fork, heat and penetrating oil. Finally was able to get a pitman arm puller to take hold and used the impact. I don't trust the joint so I have another that I can install on the jeep.
Bigwalton, that's a good...
The rest is just in the reverse order. Ended up replacing the bearing seal on the shafts and repacking the bearings. Waiting for the wheel bearing seals to come in, along with the dust shields and tie rod boots.
Forgot to mention, use a bottle jock under the knuckle to start pressing the lower...
Naturally I didn't take pics of pressing the new joints in. Found it easier to press the upper joint 1st, then the lower joint. If you have ball joints that you have to grease, make sure you point the grease fittings in a position that you can grease them on the jeep.
Once spindles out, pull the axle shaft out and remove the tie rod from the knuckle.
Put a socket, ratchet, and extension bar and the lower ball joint nut came out. Used a milwaukee 18v impact wrench on the upper nut, made it nice and easy. Leave the upper joint nut on (learned to flip the...
Pulled the washers and nuts off. Pulled the bearings. All were in good shape.
The dust shield has enough rot to justify ordering a pair. I got a spindle socket to pull the spindle (much easier than heat, screw driver and hammer). Couldn't find the slide hammer so did the next best thing...
Repainted some rims, aircraft paint stripper didn't work good enough so sandblasted, primer and painted. Tried on the set of maroon rims, didn't work. Sandblaster wasn't strong enough.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.