Search results

Hello everyone! I have been out of town for 3 years and came back and I need to get my scrambler running again. Does anyone know of someone in the Nashville, TN area that works on CJ's? I also need to get new floorboards for the front because they rusted out. Thanks!!

I will check to see how they are wired but I'm 99% sure it is all stock wiring. I don't have a volt meter but I do have a test light. I'll try checking to see if it has power at those point and get back to you. Thanks!!

It was the tach!!! I just had one of the red wires hooked up wrong. The moment I plugged it in it fired right up! :D Now the only thing that isn't working are my headlights and reverse lights. The parking lights and interior courtesy lights work fine. I have replaced the headlight switch and...

Omg this thread is perfect! Thank you!! I am going to try testing all of those connections to see where it's broken. This is the best thread I've seen describing the testing procedure. I'll report back here when I've figured it out. :)

Ok so I have narrowed my starting problem down. When I try to start it, and turn the key to the start position it starts, but as soon as it springs back to the run position, it shuts off. I can't figure out if the issue is happening because I took off the steering wheel when taking the dash...

Ok thx for the info. I'm going to try the grounds and then swap out the ignition module. I would go dui but I already have an hei setup and don't have much time to get this working before I leave.

Oh that is good to know. What did it do when it went bad? Was it cranking and not starting?

Ok glad to know that it is not the neutral switch. I'll stop trying to find it. :) That is fantastic info on the wires! Thanks so much for helping with that!!! I know with the old ignition module, if you leave the switch turned on in the "on" position, it burns up the module. I had that...

Ok thanks. But would any of the dash grounds cause it not to start?

Also my headlights aren't working but my parking lights are, and my brake lights work but my reverse light don't. I have already replaced the headlight switch and the headlight dimmer switch. I think o am missing a plug somewhere.

Hi all, I have been a long time lurker of this forum and I am doing a 1982 scrambler restoration. I have an automatic transmission and an inline 6cyl engine. My problem is that I took off the dash and all the gauges to redo the dash and since then I cannot get my jeep started. I have put back...

Looks good! I currently have a 4" BDS lift on my scrambler with a 1" shackle. I would like to put a reverse shackle kit on it, but I actually want to keep my 33's so I was hoping it might lower it a little bit so they will fill the wheel well more. If I put a stock height shackle and reverse...

1982 Scrambler, Black & Gold, 4.2L, Automatic, 4" BDS Lift, Fox shocks, 33s on 20" Rockstar IIs, Tuffy center console and rear speaker/storage boxes, Pioneer stereo system, Team rush upgrade, MC2150 Carb, MSD ignition.