• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

1984 cj8 Caster angle off

Mwood1129

Member
City
Pooler
State
GA
Why would my caster angle be off ? I have stock springs stock size tires. I had to install 8° shims and the steering wheel still doesn’t return to center around turns. And handles squirrelly above 55mph
 
If stock springs and tires I wouldn't think your caster would need shims to adjust. Did you install the shims with the fat end towards the front or rear of the jeep?
 
They are installed so that bottom of the spindle pitches forward. But my ultimate question is. Why if everything is stock, why would the caster be off ? Best I could find is for my year. I need 6°-8° negative caster. Before adding the shins I had 0° caster
 
You shouldn't need shims.
Stock springs and stock tires (I assume 235/75/R15)... never had shims from the factory, so why did you think you had to install them?
Post up a picture of what you did so we can try to help.
Also, did you have it aligned recently? Or anything else change? Shackles stock length?
Steering updates (ball joints/tie rods/drag link)
Just trying to figure out what else might have changed as something doesn't seem to add up.

cb
 
They are installed so that bottom of the spindle pitches forward. But my ultimate question is. Why if everything is stock, why would the caster be off ? Best I could find is for my year. I need 6°-8° negative caster. Before adding the shins I had 0° caster
How are you measuring caster angle?
 
Just to make sure is this a stock Jeep Dana 30 or something like an IH Scout dana 44?

You said negative caster above, you want positive caster. Adding positive caster effectively rolls the steering up and lowers the pinion.

As @certifiablejeep stated, pictures would help. Longer shackles would also decrease positive caster.

8D111305-014C-4909-B3A4-D8384ADAB380.jpeg
 
Back
Top