- City
- Claflin
- State
- KS
I'm finally getting around to assembling my AMC 401 to swap into my 360 equipped '85 CJ8. Been a while since I've built a complete engine so I want to double check on a few things. The '76 FSM for the 401 calls for Permatex no. 2 on the chamfered edge of the rear main bearing cap and along the top and bottom of the lower rear main seal end tabs.
Is Permatex no. 2 the product of choice to use on these specific places on the rear main, or is there a better product out there now to use? I've seen others use black RTV, or some sort of anaerobic sealants like Loctite 518. I know products like this have advanced from what the factory originally had available so I want to make sure I'm using the best stuff possible.
In the past, I've used Permatex no.2 or Aviation form-a-gasket no. 3 as gasket dressing on the timing cover, water pump cover, valve covers, and oil pan, etc. when a cork gasket is used (had an old school high school auto mechanics teacher who did this as well). When a rubber gasket is used, I never apply anything else, only to make sure the surfaces are extremely clean.
Head gaskets I use the supplied gaskets only.
Intake manifold, RTV around the water ports only (at least I believe this is how I built my last AMC V8, been over 10 years).
What is everyone's recommendations for the rear main seal, as well as other areas that do, or do not require any additional sealants other than the standard gasket? Some of you much more frequent engine builders, what are your recommendations?
Sent via smoke signal
Is Permatex no. 2 the product of choice to use on these specific places on the rear main, or is there a better product out there now to use? I've seen others use black RTV, or some sort of anaerobic sealants like Loctite 518. I know products like this have advanced from what the factory originally had available so I want to make sure I'm using the best stuff possible.
In the past, I've used Permatex no.2 or Aviation form-a-gasket no. 3 as gasket dressing on the timing cover, water pump cover, valve covers, and oil pan, etc. when a cork gasket is used (had an old school high school auto mechanics teacher who did this as well). When a rubber gasket is used, I never apply anything else, only to make sure the surfaces are extremely clean.
Head gaskets I use the supplied gaskets only.
Intake manifold, RTV around the water ports only (at least I believe this is how I built my last AMC V8, been over 10 years).
What is everyone's recommendations for the rear main seal, as well as other areas that do, or do not require any additional sealants other than the standard gasket? Some of you much more frequent engine builders, what are your recommendations?
Sent via smoke signal
