• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

AW4 ODB1 swap.

brandxman

Legacy Registered User
City
Glendora
State
CA
Currently have a '95 ODB1 4.0L bolted up to my CJ with a stock T5 5 speed transmission. Hesco harness gets the 4.0L plugged in and running great!

I was recently able to get an ODB1 AW4 and nearly everything related to the transmission for swapping into my CJ from a '95 Cherokee XJ.

My question is does anyone have wiring information for matting these two ODB1 items together? I have read over the many write ups on the internet, but so far I have only come across the ODB2 versions and these are totally different systems.

Any suggestions are welcome!
--B
 
Call Hesco again, they can help.

I am pretty sure they offer a "modifed harness" for the AW4 setup. I think the changes are essentially to tie in to TPS and either tach or crank position sensor I believe.
This tells the little transmission module (which has harness of its own) how fast you are going and how agressivly you want to adjust your speed( ie: what gear to go to).

Sorry, I have no diagram or wire colors though.
 
I would have said if you had the orginal harness and computer from the engine and the transmission harness and TCU that they would just plug together. But since you went with Hesco the first time you might need to ask them. I am doing the same swap of a 93 4.0 HO ODB1 with an aw4 ODB1 into my 8 at the same time from the same vehicle using all the orginal harnesses and computer/TCU so I believe it will be plug and play for me I hope.:fingerscrossed:
 
Back
Top