• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Door hinges - brass inserts won't fit?

tower210

Scrambler Junkie
Lifetime Member
City
Olathe
State
KS
So I purchased new brass inserts from q-tec a while back, and finally getting to the season to put doors back on. The problem is, the hinge ID is about 10.10mm. Had the brass in the freezer bout a week, and the smallest number I can measure is 10.35mm OD.

Thoughts? Ideas?

Tried using a punch that was very gradual to "stretch the hole" and had no luck.
 
Last edited:
Sounds like you need to chase the hinge with a 13/32 bit

Sent from my HTCEVOV4G
 
Those brass inserts probably won't help on mine. The lower is worn pretty badly, to were the upper and lower halfs have a lot of misalignment... Do I need to just find good used hinges?

Sent from my HTCEVOV4G
 
Back
Top