• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Engine Stand

leeherron

Legacy Registered User
City
Pensacola
State
FL
Okay .. maybe a dumb question, but someone asked me and I had no idea.

How safe is it to mount the 258 fully equipped onto an engine stand without possibly damaging the transmission bolt placements on the block?

That said, because we weren't sure, we placed a small support forward .. see pic.

attachment.php
 
I've done it and never had a problem. That 2x4 supporting the front isnt a bad idea though.
 
What's the stand rated at? How much thread engagement do you have in the block?

Rule of thumb on thread engagement: you want at least the diameter of the bolt screwed into the block. 7/16" bolt? 7/16" thread engagement. But ideally, as much as it'll go in, do it. If it's too little, you risk pulling threads.
 
Full thread engagement. Stand rated enough .. wasn't sure about the stress on the transmission mounts and that level of leverage.
 
Nah, you're ok. The front of the engine will dip down a little as you found out, but as long as the stand will hold it, you're good.
 
I have had a 4.0L & there is a 258 on same engine stand in my garage right now without any problems. Originally the 4.0 we thought it was secured but the bolts are a different size & it dropped on its head (was upside down at the time). Fortunately no one had any feet under it when it dropped. Long bolts with nuts through the holes fixed that! My stands are rated 750 lbs. Yes they move a little & I make sure to not put any body parts under it. The brace is a great idea. Saftey is always paramount! :thumbsup:
 
Back
Top