- City
- West Friendship
- State
- MD
I'm trying to get the Jeep for an extended trip in June/July (guess where??). I want to try to make it as reliable as possible and set it up for (hopefully) years of future use. It is a pampered road Jeep for the most part, although my son occasionally gets it dirty. It will not be wheeled. I expect I'll be touching on all parts of the Jeep. However, my first question is the frame. This was originally a Michigan plow Jeep. The PO welded on some replacement plates. Not sure of the source. I've been book learning about welding and these look a little gamey to me. These pictures are a series from along the drives side frame. The mottled appearance is due to the owner putting preserver on the frame that he'd had galvinized without proper prep What does everyone think? It's worked fine for a couple years. Am I making much ado about nothing, or are you going to have problems sleeping wondering if the whole thing will explode? If the consensus is that it is a timebomb I'll probably go right to a TDK. Any comments MUCH appreciated!




























Hopefully with the galvanizing and the other prep it will continue to hold up and I can use that money on a axle regear, but that's my next topic