• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

front dana 60 locker...what type?

scott anderson

Old age Mutant Ninjaneer
City
Paragould
State
ar
I am in the process of rebuilding a dana 60 front that will go into my 8...i dont like how the gears are set up now...they seem to have too much backlash, so i am going to set them up again...so i thought it would be a good time to put in a locker...1st question...what type would be best...this only gets locked in on the trail...2d question....what about welding the spiders....does anyone have their front welded and if so what are the trail manners...?...all responses and advice appreciated:confused:
 
Scott, I just put in Eaton Detroit Electric Lockers, front (44) and rear (60). Just got back from Moab last week and really liked them. Very quiet and instantaneous. Installation seemed pretty clean with just one small hole for the cable which controls the electro magnet. Cheers Kim
 
The thought of selectable lockers makes the money hairs stand up on the back of my neck....but...i may be over reacting...i would love a selectable in the rear, is it work the money in the front, since the front will be not be used on the road?....who has the best price on the eaton?
 
Lockers

Scott - I use a spool up front and i am sued to it. I know that your turning radius is compromised, but you can always do a front dig if you are using twin sticks. It wants to crab on you in turns when you are riding down a trail. This would be the same as welding spiders.

I have seen people use selectable lockers so they can turn on a dime so i guess it is how you want your rig to work. If you can get used to the spool idea then i say it is not bad. I like mine. Plus it is way cheaper.
 
I think i will probably got the route of welded/spool....i am already over budget on this project (axle looked good from the outside, but when i started taking it apart, it had no grease in the wheel bearings, the knuckle bearing was completely dry, and the axle tube was packed so full of sand that the axles would not slide out.) Lets see what the bulk of the opinion is....


also, where is the best place to buy kingpin repair kits?...parts mike has them but he does not have online ordering...
 
Detroit

I run a Detroit in my set-up, i'm happy so far. I run a spool in the rear.
 
Detroit x2

Yup get the detroit in front, spool the rear and instal the twin sticks to get your moneys worth.

Buy all you axle shtuff from Randys Ring and Pinion, they've got it all, plus theres an ex-scrambler guy working there.
 
I finished taking this thing apart toniight...every bearing and seal will have to be replaced...the tube seals worked...thank God...so the gears are ok...i found out why there was too much backlash...i took the pinion nut off with a half drive ratchet while i held the yoke with my hand...i think probably 10 ft lbs...i am lucky that the gears are good...by the time i get this thing rebuilt.i would have been able to almost bought a currie axle
 
We use nickle rods to weld up the demo derby rearends (10 bolt). The flux core kept breaking. Personally, I'll have a selectable. ARB all the way, then you have an excuse to have On Board Air.
 
Back
Top