Front Hub reassembly

[valkster]

Hey, all. I recently took the front wheel assemblies off and went through them as part of my restoration. While I was working on it I deciided to disassemble the locking hub units to clean the internals and paint the housing. What is the proceedure to get the unit put back together so the dial lines up with the "2" and "4" on the hub? I should have marked it during disassembly but failed to do so. Thanks in advance.

-Mark

 

[kctango]

see if this helps

 

[valkster]

Thanks..I think I figured it out. I had that document but I took the "body assembly" apart...the plastic gut inside the hub and it really didn't go into working on that part. It took some fiddling but I got the knob and guts timed together so they engage and disengage properly. Fortunately there was no wear to speak of inside.

-Mark