• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Fuel guage not working.

Wyatt1234

Basic User
City
Orange
State
TX
On my 82 scrambler i have a new fuel sending unit, and all the wires appear to be hot. But my fuel guage still wont work. I have read that the reproduction ones are junk, is that true? If all else fails I can mount a universal one under my dash. Though I would like to reuse the oe style guage. Any help would be appreciated. Thanks.
 
The fuel gauge has a small set of points inside it uses as a voltage regulator. On the new gauges the quality is quite different from the OEM. The gauge must be grounded well or when you power it up it will melt the windings and the points and will not work


 
They shouldn't all be hot, as in have 12v on them relative to ground. If so that is a problem.

At the gauge:
The red one (usually its red) will be 12v from battery system.
The pink one (usually pink) will be the wire from your tank sender. This one is variable resistance relative to ground depending on how full your tank is.
Looking at the back of your gauge there is a strap bolted between the temp and fuel gauge. This strap sends the regulated voltage your fuel gauge creates (as Falkland said) to the temp gauge.

If you look at your new fuel sender:
One wire is pink and goes to the gauge.
One wire is black or blue (mine is grease-and-mud color) and goes to a bolt on the frame as ground. This one is important as it is usually the ground that causes problems. Make sure it is a good ground wherever you connect it.

If all those are doing what they are supposed to relative to ground, then check your components. Here is a good article:
http://civilianjeep.info/Strenk/Gauge%20web%20page/basic_troubleshooting_for_cj_gau.htm
 
Back
Top