• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Hydraulic clutch install

no clue from here...sorry.

Man,
I can't believe the guys from Novak or AA couldn't help figure it out!?! I am heading into similar murky waters soon myself and can only hope to not have the same experiance. But I am swapping a TF999 for a NV4500 I have...that should be a nice change. Add crawl gear and OD!:smokin:
But I am slowly planning it all out now while I am here (Iraq) so I can (at least try to:rolleyes:) get all parts and numbers lined up ahead of time. I still need to find a pedal assem. and bits and parts...but I'm hoping it won't be any worse than having to hoist that monster into the belly of the beast!
 
I would have preferred to go that route..but I had to keep cost WAYYYYY down. This whole swap has only cost me under 300 bucks ( got the tranny for a song, 10 over wholesale on clutch, pedals were free etc..).
I think the NV trannies have been done to death...and recently. I dont think anyone has swapped in a t-5 by choice in quite a few years.
I may still go with the Novak 3/4 inch slave..but for now I am happy with where it is at.

And for all the purists out there... I didnt use regular allthread, since it is only grade 5, which likes to bend. All the grade 8 bolts in 6" length are only threaded an inch or so..(not enough) . I went to the local hardware store and found a stainless eye bolt about 8" long that was threaded almost a full 3". Cut off the eye, taper the cut end for the slave , add a couple washers/nuts, and presto!! durable linkage adjustment!!
 
Glad to hear that you got your clutch straightend out . How's the pedal pressure with the three finger?
 
its a little heavier...but not too noticable...then again I dont think the clutch in a KW or 6000 series Chevy with a CAT diesel is heavy either!!
 
Back
Top