• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Kentrol Glass body P!SSes me off!!

Kane

CJ-8 Member
City
Berlin
State
ct
So exactly one year after I bought my basket case 84 I finally got to put the body on the frame for mock up and fitment. To say this body doesn't match up would be an understatement. I bought a Kentrol fiberglass body from a person in New York last year for less than half price of new. He bought everything to build a wheeler and never touched the build so this body was brand new. Well I put the body on and the mounts on the tub for the two by the doors are off by about 3 to 4 inches each. They have square mounting pads that are metal encased in the glass so you can drill and tap them for mounts. Great idea but since they do not line up now I have to either fab some sort of misalignment bracket or cut of the mount and move it over to the right spot. Oh and the front mount for the body (not the grill) sits a little lower so it pushes up the grill to leave a nice 1 1/2 gap there so the jeep looks like it has a body lift. The rear section body mount that is under the roll bar also has a nice 3.5 inch gap. The original body apparently had an extra body bracket that goes across to both sides for support. Then I get to the back. The bumper mount cross member area. The mount locations on the glass tub are about 2 inches further out from were those stock frame holes are located.

So after I had the tub, fenders and grill on I decided to drop the fiberglass hood in place just for looks. The fenders and grill are original metal. I put the hood and on it looked a little short. I line up the front with the proper overhang and noticed a huger gap by the tub where the hinge's would go. So I measured the length of the hood to he original metal one. The glass hood is a 1/4 inch shorter?!?! Really, they couldn't even get that the right length. If I bought that hood new it would cost $600. I bought it and the fenders for $150 but $600 for something that doesn't fit. I never installed the fenders so who knows if they will work. Too bad because my CJ5 was going to have the 1 piece clip removed so I could install these. Not now.

I tell you what. I bought a Shell Valley body for my CJ5 back in 1993 and I still have it to this day. That body lined up perfectly and still looks brand new. This is why I was sold on staying with glass living up in rusty New England. Good thing I have a welder and some skills because if I didn't this tub would look like a hack job when finished. One thumb down for Kentrol. :banghead:
 
Wow sorry to hear all of the trouble you are about to go thru..... I have a friend that had the same amount of problems with a fiberglass tub for a 7. I don't know what brand is his but at this point I would not be surprised if it was the same one. Good luck in the project...
 
Wow! that sounds very strange. Any use in contacting Kentrol to see what they would say about it?

Also, if you move your body mounts on your frame, I have found it works best to not rely just on measurements, but to actually bolt the mounts to the tub, situate the tub where you want it on the frame, tack weld the mounts in place, then remove the tub and finish the welds. You probably already know all this, but speaking from experience, I could have saved a lot of time and effort if I had gone directly to this route instead of some of the other things I tried.

good luck and keep us posted!
-Mike
 
Back
Top