• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Lifted and leaning

Grey Fox

SOA Member
Lifetime Member
City
Bountiful
State
UT
So I'm lifted SOA with Old Man Emu 2 1/2". I've got this lean to the left that drives me nuts. I thought I must have gotten weak leaf springs on the left so I was planning on swapping the left side springs with the right to see if that changed anything. I just read the post where a left lean is a common issue on lifts. Really? Why? Any fixes?
 
Fat *** in the seat. LOL I just couldn't resist. I've heard of that you might check your body bushings. The driver side does get more wear due to there only being a driver a lot of the time.
 
Check the steering stabilizer bracket to see if it's on the low sided leaf. I had that problem early on because it had been sandwiched in and lowered my leaf which lowered that side. Check it out and let us know.

Tiny


nevermind... I just noticed you went spring over... :rolleyes:
 
Last edited:
I called Old Man Emu Company and the customer service person said it was common for them to ship one spring that would have a stiffer rate and that that spring should be mounted on the drivers side. Last night I pulled the rear leaf springs off and sure enough there was a difference. Check out the pics.
 
tinymay said:
Check the steering stabilizer bracket to see if it's on the low sided leaf. I had that problem early on because it had been sandwiched in and lowered my leaf which lowered that side.


That bracket is only ~1/8" thick...shouldn't be that noticeable.


Grey Fox said:
I called Old Man Emu Company and the customer service person said it was common for them to ship one spring that would have a stiffer rate and that that spring should be mounted on the drivers side.

Did they give you an explanation as to why?


Craig
 
Did they give you an explanation as to why?


Craig[/QUOTE]

The customer service person I talked to actually was in the Toyota Div so he really wasn't familiar with Jeep. He said on Toyota's they are weighted slightly heavier to the driver side with their equipment placement. So on many of their kits one spring would be stiffer. After hearing that it gave me just enough of a reason to pull them off. After I swap them we'll see how level she sits. I might be looking at the front leafs as well for the same issue. It would appear to me the the CJs are fairly balanced and wouldn't need different spring rates. Kim
 
Just a follow up on this. Swapped the 2 rear leaf springs and she sits very close to level. Cheers
 
Back
Top