• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Looking for Frame Repair Adivce

Dmcgi97502

81 Scrambler rebuild
City
Naperville
State
IL
I've been working my way from the front of the frame to the rear to get it ready for paint but I've put off the holes in the back long enough! A previous owner took some angle iron and welded it over the rust holes and then welded the spring hangers to the angle iron. It works ok but I am looking for a better way to do it. My thoughts are to cut out the rust and weld in new steel and support with the rear frame plates I bought from Chiefawho (which are really nice). My other thought is to chop the last couple feet off the frame (right behind the wheel bend) and fab a new section then butt weld it in place and brace with frame supports. Has anyone tried this? Will it be strong enough? I'll attach a couple pics for your enjoyment!
 
Repair advice

when my frame came back from being acid dipped, I cut out all the rust and made patches from a cj-7 frame, I will finish with my plates bought from chief Wahoo
 
I too have a similar problem. I posted a few days ago in another thread about the differences between CJ7 and CJ8 frames (Where is the difference in the frame between CJ-7 and CJ-8?) but no one has responded yet. Maybe too stupid a question? :confused: Anyway I too was hoping to maybe use part of a CJ-7 frame to make repairs with. My understanding with the frame plates is they don't go all the way to the rear of the frame but come up 6" short. Is that true? Most of my damage is in the section right where the shackle hander is - the last 23" of frame. Any advise?
 
Yes that is most helpful. How did I miss that one. :confused:

So looking at this drawing, dimension "H" in the rear section shows a length of 46" for the CJ-7 and 70" for the CJ-8; the 24" extra that is alway referenced between the two vehicles.

The question I have is where in that section of frame is the actual length applied? And is the differences in hangers locations is what being referred to in item 6 (Scrambler) verses item 7? Still not clear to me where the difference is.
 
I'm in the middle of doing this exact repair. My rust spots are in the same location and probably as bad if not worse than yours. I'm using 3/16 plate steel to box in the area. I'm taking pictures of the process and was planning on posting them in 2 or 3 days when I get a little further on. I'm also doing this with the body still on. Cheers, Kim
 
Grey Fox,
Thanks for the post. Most encouraging. Looking forward to your pics and successful report.
 
jhpribbeno said:
I posted a few days ago in another thread about the differences between CJ7 and CJ8 frames (Where is the difference in the frame between CJ-7 and CJ-8?) but no one has responded yet. Maybe too stupid a question?

No not a stupid question at all....you may want to pm JohnN, since he has a scrambler and a cj7 sitting side-by-side in his garage. I'm sure he'll help you out with whatever you need on that.


-Mike
 
WildTurkeycj8 said:
No not a stupid question at all....you may want to pm JohnN, since he has a scrambler and a cj7 sitting side-by-side in his garage. I'm sure he'll help you out with whatever you need on that.


-Mike

Thanks Mike, PM sent.
 
i was on here looking to find the exact measurement of the difference between the 2nd and 3rd body mount.
about a year ago someone had the dimension. i believe itwas about a10.5 to 11" frame add in the center.
 
Back
Top