• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

maximum driveshaft ujoint angle

BDCCLARK

Active member
Lifetime Member
City
gravois mills
State
MO
What have you done to your lifted scrambler to keep rear driveshaft ujoint angles reasonable? Mine has about 4 inches of lift. My rear pinion sits at 2ish degrees up. My tcase sits at 3.5ish down. My driveshaft sits at 18ish degrees. Is 16ish degrees of ujoint angle too much?

Thanks, Chris
 
Last edited:
That's a similar lift to mine. I have Tom Woods shafts but no CV joints or special mods. Mine is very comfy cruising 80 with no vibration. I think a 7 would need a CV joint but our shaft is long enough to be fine.
 
Thank you Chamba. I'm running what I believe to be 4 degree shims in the rear. The previous owner had the shims in the opposite direction. There was about 9 degrees of separation from the tcase and the rear pinion. It was set up more for a cv shaft I feel. I spun them 180 degrees yesterday morning. It seems to have helped alot. Do you have any build documents or pictures of yours? I've really considered a sbf engine too.

Chris
 
I don't have a build thread unfortunately.. I'm not very good at documenting things I do like many guys here unfortunately. I'm happy to send you any pictures you think could be helpful though.
 
I'm the same way. Is your wheelbase stock? Any idea of your rear driveshaft degree. If you have a good picture of your rear driveshaft that I can compare mine to it would be nice. If you don't, that's cool too.

Chris
 
Back
Top