• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Need help with headlight switch removal

Breal

Scrambler Junkie
Lifetime Member
City
Jackson
State
WY
I was able to find the spring mechanism to release the pull knob but know I am having trouble figuring out how to remove the retaining piece. I'm assuming that the donut shaped piece is threaded onto the center cylinder. I tried using two screwdrivers in each notch on either side of the donut and applying counter pressure on each side but can't get it to budge. After several attempts and one slip of the hand scratching the dash I figured I should quit and make sure I am doing it right. It looks like it could be rusted in place.

Any thoughts on the best way to get the headlight switch out?

50abe3d14794434f1a81f509b912d4e0-1.jpg
 
I've cut sockets and tubing to make tools to get those off.

835fccf6281a88dd3ea145324e9bc1a4-1.jpg


Sent from my SM-G920V
 
That is exactly what I do as well. A non rusted one will normally come off pretty easily, but for the really stubborn ones you need to make the tool. Also having the tool allows you to get the switch nice and tight again so it doesn't loosen up and wear out the hole . Also put a little lube on there, a drop of penetrating oil etc to help loosen it up, but if you spray, not anything that could bubble up your paint.
 
I have used needle nose pliers, one side in each groove.
 
I have used needle nose pliers, one side in each groove.

Thanks, That was the first thing I tried with no luck. But the nose of the pliers were just barely to big to get a good connection to turn it. I may run by the hardware store to see if I can get some finer point needle nose. Thanks again.
 
I've cut sockets and tubing to make tools to get those off.

835fccf6281a88dd3ea145324e9bc1a4-1.jpg


Sent from my SM-G920V

Have one you'd sell to me by chance? My preference would be to have the right tool for the job but I don't have the capabilities to make one myself.

Any chance if I bought a new switch assembly that it might come with one of those?

My intention was to see if I could clean up and repurpose the same part due to a bad connection with the dash lights. But if a new assembly came with the tool I'd just assume to go that route.
 
If you have a good set of snap ring pliers, that may also work in a pinch.

Sent from my SM-G920V
 
That is exactly what I do as well. A non rusted one will normally come off pretty easily, but for the really stubborn ones you need to make the tool. Also having the tool allows you to get the switch nice and tight again so it doesn't loosen up and wear out the hole . Also put a little lube on there, a drop of penetrating oil etc to help loosen it up, but if you spray, not anything that could bubble up your paint.

I'll try the penetrating oil too. Thanks.
 
I use angled snap ring pliers. But that socket would look great in my box lol

Sent from my SM-N910P
 
did you try with a screwdriver (small enough to fit left groove)with the help of a hammer, gently loose the locking nut?
 
did you try with a screwdriver (small enough to fit left groove)with the help of a hammer, gently loose the locking nut?

After slipping and scratching the dash I decided to just find the appropriate tool. I ended up buying that one off ebay.
 
Back
Top