I'll be looking forward to your report on any effect that the bump in the initial timing has had.
Before I post a vacuum diagram I'd like to chat with you with regard to a vacuum system that should prove to be of advantage.
With your having both a three port as well as a five port CTO is indicative of having been equipped with Heavy Duty Cooling. This system relied on Manifold vacuum signal for Vacuum Timing Advance at the startup and during engine warm up, converting to a "S" ported signal while the engine was at normal operating condition, then at any point in its operation if the engine started to overheat (which by the way was the design intent of ported vacuum, not that it was used to bring on excess overheating but rather to keep the engine exhaust hot enough to burn pollutants in the cat converter) it would revert back to the Manifold in order to cool it back down to the temp that ported vacuum was applied once more.
My suggestion is that you consider using Manifold exclusively, there are advantages with doing so.... unless your CJ is still equipped and or you have plans to maintain a Catalytic Converter.
Brings to mind that you've mentioned the EGR being disabled. If you have the Cat and have maintained a stock exhaust system the EGR is worth bringing back into operation. If there is no Cat and the exhaust has been modified to the standard of a more free flowing exhaust than the original system then that attempt would be futile.
To the Weber;
The means to complete satisfaction with this carb is to adhere to the Redline Weber Tune Guide.
In it you would see that the speed screw should not be turned inward more than 1-1/2 turn. And then that a lean best setting at the mixture screw should not exceed 2-1/4 turns out. The intent in this document is not to establish an idle speed as much as to evaluate the mixture strength to support the engine demand throughout the transition from the low speed circuit (idle speed thru 2000 rpm) into the high speed circuit.
A lean best setting is that which will cause a hiccup (slight lean misfire) at say every 10-15 seconds.
On the fully warmed engine and after a bump on the pedal, I urge you to set the speed screw and leave it at 1-1/2 turns in once the tip contacts the stop.
Then preset the mixture screw to say 3-1/4 turns out. At idle work that screw inward at no more than 1/4 turn an then allow enough time for that turn to have an effect to the idle quality then another, allowing time for that reaction, then another until a rather constant misfire occurs. Then work it outward at say 1/8th turns until that hiccup all but disappears... be patient as each adjustment to this screw will have an effect, if you allow the time between each tweak and if the throttle plate is closed to that preset or to the point that zero vacuum signal is evident at curb idle speed.
If you should need a Tune document give out a shout and let me know what your intent is with the vacuum system set up.