• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Novak AX15

J

jg_99

Legacy Registered User
City
Richmond
State
tx
I hope someone has done this before.

I would like to replace my factory 4 speed. Considering the Novak AX15. They have put together a complete package.
Hydraulic clutch master, bell housing, adaptors, standard shifter, etc.

They can not tell me if I will have to cut the tub. I assume the cover plate will need to modified. My scrambler is very clean with zero rust, and i do not want to cut it up.

Also should I spring for a new flywheel ?

Any pit falls I need to be prepared for ?

Better solutions ?

Thank you in advance

Jim
 
I did a 4.0FI/AX15 install in my 81. We used a Advanced Adaptors clocking ring to mount our D300. The stock AX15 external clutch master and slave cylinder setup was easy to fab/install. The trans cover had to be modified. Since the shifter now comes thru at the rear of the cover. Also had to custome fab a trans mount. We have no regrets about doing the install. We didnt use the kit. We found a good AX15. Got any new part needed from Rockauto.com. We would be happy to assist if you have any other questions about the swap.
 
thank you for the replay

I purchased a Novak conversion. Just have to find the time to install.

Jim
 
I believe Novak also has an uncut trans cover that is rolled to the proper radius for your Scrambler's floorpan. Good Luck on your conversion, you will have no regrets
Paul
 
Paul

Thank you, the guy at Novak was very helpful and knowledgable. But he did not mention that had trans blanks

Ill call them tomorrow

Jim
 
You must log in or register to reply here.
Back
Top