Hi guys,
I'm currently gathering parts for my LS swap & NV4500....trying to do it the cheap way...but there's just not cheap way with this combo...I have invested (spent is a more accurate word) and still need some parts (axle related)..the AMC20 can survive if modified (one piece axle and truss) ...the D30 not sure.
If a NV4500 is a "must have", search for a NV4500 out of a Dodge gas 3/4 or 1ton pick up...early 90s...it mates directly to the d300 _yes no adapter needed_ it's a 23spline with the correct bolt pattern for the d300 in the CJ.....
you would need to replace the dodge input shaft for a chevy one ($75) & modify the retainer (length) ($40 job at a machineshop) ..and then it mates directly to a chevy bellhousing.
Only down side of using this mentioned dodge nv4500 is that the tail cone/talhousing is too tall (well, the opposite actually) the tranny crossmemeber will be hanging too low in your CJ......an aftermarket tailhousing can be purchased to avoid this too low hanging issue ($$)
Assuming you will be cruising at 75mph on 33s or larger, with the chevy engine, you won't need OD if you have 3.54 or higher gears (lower numerical)...if you have 4.10 or lower then its a different story..
If starting over and using stock gears I would do a doubler tcase for the offroad times...the 8 is long enough for a doubler...and would use an old manual 4sp.
save on adapters and gears, consider a doubler or an atlas inclusive, you would be in the same or lower overall cost range...
my 0.02 MX pesos comment
Pedro
I'm currently gathering parts for my LS swap & NV4500....trying to do it the cheap way...but there's just not cheap way with this combo...I have invested (spent is a more accurate word) and still need some parts (axle related)..the AMC20 can survive if modified (one piece axle and truss) ...the D30 not sure.
If a NV4500 is a "must have", search for a NV4500 out of a Dodge gas 3/4 or 1ton pick up...early 90s...it mates directly to the d300 _yes no adapter needed_ it's a 23spline with the correct bolt pattern for the d300 in the CJ.....
you would need to replace the dodge input shaft for a chevy one ($75) & modify the retainer (length) ($40 job at a machineshop) ..and then it mates directly to a chevy bellhousing.
Only down side of using this mentioned dodge nv4500 is that the tail cone/talhousing is too tall (well, the opposite actually) the tranny crossmemeber will be hanging too low in your CJ......an aftermarket tailhousing can be purchased to avoid this too low hanging issue ($$)
Assuming you will be cruising at 75mph on 33s or larger, with the chevy engine, you won't need OD if you have 3.54 or higher gears (lower numerical)...if you have 4.10 or lower then its a different story..
If starting over and using stock gears I would do a doubler tcase for the offroad times...the 8 is long enough for a doubler...and would use an old manual 4sp.
save on adapters and gears, consider a doubler or an atlas inclusive, you would be in the same or lower overall cost range...
my 0.02 MX pesos comment
Pedro
Last edited:
