• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

One piece axle kit seal and backing plate fitment

jc_chandler

Well-known member
City
Durango
State
CO
I just got a one piece axle kit for the 20 and the seal that came with it doesn't seat in the backing plate hole leaving about a quarter inch gap between surfaces. The instructions don't mention enlarging the backing plate hole and the few videos I've seen on youtube don't either. Hopefully the pics show what I mean. Is that expected? I want to make 100% sure before I press everything together (after cleaning the backing plates of course).
PXL_20210202_004536608.jpg PXL_20210202_004555636.jpg
 
Seal should fit. Do you have the original seal. Compare the two. I Just had to replace the inter seal on the alloy usa one piece that I have. They used stock seals (inter and outer). Here's some pics, don't know if it shows enough. You can see the seal fits in the backing plate in the one pic.
 

Attachments

  • 20210125_141844_resized.jpg
    20210125_141844_resized.jpg
    143.8 KB · Views: 8
  • 20210125_143330_resized.jpg
    20210125_143330_resized.jpg
    128.9 KB · Views: 8
  • 20210125_143417_resized.jpg
    20210125_143417_resized.jpg
    177.9 KB · Views: 8
  • 20210125_151127_resized.jpg
    20210125_151127_resized.jpg
    125.9 KB · Views: 8
  • 20210128_151521_resized.jpg
    20210128_151521_resized.jpg
    83.8 KB · Views: 8
  • 20210128_151803_resized.jpg
    20210128_151803_resized.jpg
    133 KB · Views: 8
  • 20210129_125807.jpg
    20210129_125807.jpg
    139.3 KB · Views: 8
  • 20210129_125819_resized.jpg
    20210129_125819_resized.jpg
    138.1 KB · Views: 8
Thanks for the pics, the two of the backing plate give me a great idea of the fitment. I do have the original seals, though they are trashed. What's left of the the rubber does appear to be a flush fit with the backing plate, so I think the seals that came with this kit won't work. I'll pick up a couple of stock replacements and hope those fit such that the backing plate and seal mounting face are flush. Thanks!
 
It would make sense that stock would work since it has to go through the hole of the backing plate. This info came from alloy usa (unfortunately omix is the same manufacture. I checked because I wanted to make sure the inter seal (metal housing) is the same as what they use because of the spaces you have to cut to size. Good luck.
 
Back
Top