• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Pittman arm troubles

stretch1134

Basic User
City
GRANT VALKARIA
State
FL
Anyone have any trade secrets they'd be willing to share regarding pittman arm removal? I've been attempting to remove mine off my 82 cj8 for about 4 days now. Currently spraying penetrant oil every so often and i went ahead and left the puller on it under as mush pressure as i can get with a 3' breaker bar.... kinda scared I'm going to break the puller. Any suggestions?

Sent from my SM-G860P
 
Heat - this should help break any rust bonds.
Make sure the pitman arm puller is heavy duty - they do make thinner ones for smaller applications which probably won't work
 
Yes heat will help things a little bit, but you also have to remember not to get it too hot as there are rubber seals right above the pitman arm. I've given up on the pullers, I use a die grinder/small cut off wheel to cut almost all the way through to the splines and then hit the cut with a chisel bit on an air hammer.
 
Heat it with your puller fully loaded. It'll pop right off. Maybe even a love tap with a BFH on the puller bolt when it's hot enough to hurt you but not enough to change to red
 
Thanks for the help guys! All it took was a little heat and a bigger hammer!

Sent from my SM-G860P
 
Back
Top