05unlimited
Legacy Registered User
- City
- Lancaster
- State
- CA
Hi all,
I just recently upgraded my '81 "8" to a 4.0L head and Mopar MPFI. Still working on other issues with fuel plumbing, so the 8 is not running yet. I wanted to pass on an upgrade that (in my opinion) is a super idea when doing the MPI upgrade. This does not apply to a Howell upgrade, this only applies if you do the head and injection upgrade.
After the uphrade I noticed that the 4.0 exhaust has a different bend angle at the #1 cylinder port and will not allow the power steering bracket that bolts to the block and to the pump to fit correctly. You an make the bracket fit by ghacking up the bracket to allow clearance between the exhaust pipe and the bracket, but in doing so you degrade the brackets strength (unless you weld a rib around the cut out section of the bracket).
My solution was to upgrade to a later model pump with an external reservoir. The pump bracket clears the exhaust pipe and mounts to the intake manifold, and still mounts to the 4.2L warer pump. Three spacers (washers) between the pump and bracket to correct any off set issues will align the pump with the serpentine belt. The only part I had to modify was the pressure hose from the pump to the steering gear box. A radiator A/C repair shop should be able to make you a new hose.
Use the CJ hard line attached to the gear box, and the hard line from the external reservoir and measure the length of hose (add some extra length to cover the torque rotation of the engine). The later pumps are multi adjustable, so along with the ALT. adjustment tou will gain two more. You also move the reservoir further away from the hot exhaust. I will add some pictures when I can.
I just recently upgraded my '81 "8" to a 4.0L head and Mopar MPFI. Still working on other issues with fuel plumbing, so the 8 is not running yet. I wanted to pass on an upgrade that (in my opinion) is a super idea when doing the MPI upgrade. This does not apply to a Howell upgrade, this only applies if you do the head and injection upgrade.
After the uphrade I noticed that the 4.0 exhaust has a different bend angle at the #1 cylinder port and will not allow the power steering bracket that bolts to the block and to the pump to fit correctly. You an make the bracket fit by ghacking up the bracket to allow clearance between the exhaust pipe and the bracket, but in doing so you degrade the brackets strength (unless you weld a rib around the cut out section of the bracket).
My solution was to upgrade to a later model pump with an external reservoir. The pump bracket clears the exhaust pipe and mounts to the intake manifold, and still mounts to the 4.2L warer pump. Three spacers (washers) between the pump and bracket to correct any off set issues will align the pump with the serpentine belt. The only part I had to modify was the pressure hose from the pump to the steering gear box. A radiator A/C repair shop should be able to make you a new hose.
Use the CJ hard line attached to the gear box, and the hard line from the external reservoir and measure the length of hose (add some extra length to cover the torque rotation of the engine). The later pumps are multi adjustable, so along with the ALT. adjustment tou will gain two more. You also move the reservoir further away from the hot exhaust. I will add some pictures when I can.




