• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Scrambler New Body Tub Rust

Dilafert

Basic User
City
Bayamon
State
PR
Hi ,

I purchased a new body tub for my scrambler 2 years ago for a full restoration. I send the jeep to the body shop and they sandblast and epoxy prime it. After that I stop the restoration for 2 years and Im about to start again next week. I notice last week that is getting light rust on the interior bed. Does not have rust on the side panels or bottom. Is on an open garage and even though it was cover , it got water on that area and is on a hi humidity place.

Would it need to be sandblast it again and prime with epoxy the whole tub? Or would it be better to sand the whole tub down and prime it again with epoxy? I prefer to sand it down on my garage and fix where is getting rust but Im worried that It wasn't a good sandblasting job and I would get rust later after applying final coat.

IMG_5343.jpgIMG_0247.jpg
 
Probably just moisture that condensed on the floor. Looks like just surface rust. Just give it a good sanding and shoot epoxy primer on it. Make sure you sand where you apply the new epoxy. Jeep looks nice.
 
Sandblasting is good but anytime there is a delay in putting primer on with cause a flash rust. Especially with PR humidity. Treat it with Ospho or something similar to prep it between blasting and primering.
 
Back
Top