• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

seat question

ScramblinScott

Now with college degree!
City
Kennesaw
State
ga
Howdy all,

My scrambler sports a pair of bestop high back seats, they are pretty nice and I like them. I have no idea where the mounting brackets for these seats came from. I stand 6 foot 6, and when I sit in my jeep, the crown of my head pokes up above the roll bar a little bit. is there any aftermarket mount that can lower the seats a little bit??? How do i tell what brand of seat brackets they are?? and while I am on the subject, will a tuffy radio center console fit between these seats?? thanks

Scott
 
Scott, I think your issue is not the seat risers but the after market seats. I went through this same problem. I tried 3 different brands of seats and all raised me higher than I liked. You can pick up about and 1 1/2" in height if you use a rigid raiser as opposed to a rotate forward riser. Good Luck
 
Also if you eliminate the slider base and instead use a piece of flat 1/4" bar stock you can gain like 1" in height. Basically you drill it for the set back you like and then it is permenant. If you are the only one that drives the jeep this is not an issue then.

But it is a good idea. Otherwise switching to a fixed base is a good idea. Or you can construct your own and make it even lower.

Carl
 
Back
Top