• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Stainless or not for Brake and Fuel lines

fourwheelinj1

CJ-8 Member
City
Raleigh
State
NC
I am getting ready to pull the tub off and I plan to replace the brake and fuel lines. I was thinking stainless, but I local Jeep guy said that stainless is really hard to work with and get the fittings to seal. Any truth to this?
 
I'm assuming you are referring to hard line and not braided flex lines. SS is about the same for bending but I would agree it is more difficult to flare than regular steel (tends to split/crack easily). Worth the extra effort in my opinion as it will last a very long time.
 
Cupronickel its the future!

That and the fact you can not buy ready made fuel or brake lines for anything over this side of the ocean:D
 
I've got stainless brake lines and love them. I got the pre-bent lines. You local guy is correct about the fittings, stainless is a harder metal and may take a little extra turn to tighten with out a drip (personal experience, my mechanic is the one that told me about the harder metal not conforming to the other fitting as easily is steel).
 
I got the zinc coated pre bent lines from inlinetube. I cant imagine them ever rusting as much as I drive the jeep. SS is harder to bend, and flare. I suppose if you dont need to flare them then no big deal.
 
I went with coated lines for my build. Just bought it by the roll and bent it myself. In my opinion, stainless is nice, but the cost wasnt worth it for me.
Sure the stainless will last for ever, but my Jeep will never see snow and is garage kept. The coated lines will last forever in my Jeep.
Also, with the amount of times I change stuff on my vehicles, stainless would have been a waste.
 
I was trying to build a Jeep that would never rust. (Galvanized frame, aluminum tub, etc.) I knew I was doing stainless brake lines, and thought the deal from Classic Tube was perfect. I was very happy with their product, or at least how it worked out in my application. I understand that the rear line, where it meets the bracket for soft-line, is too long. Since my TDK frame didn't have that bracket welded on, I made my own bracket and just screwed it to the frame where the brake line ended. (I elected to run braided-stainless rubber fuel lines to ensure meeting pressure and volume requirements for my EFI. If I was doing a carb, I would have used Classic's fuel lines too.)
 
Back
Top