• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Storage options for bed of scrambler

For storage, I have an 8 inch deep tuffy pull out drawer mounted behind my rear seat in the Scrambler. I built a rack and mounted on top of the pull out drawer, for more strength to support an ice chest.
My high lift Mount It’s very simple. I took a long 3/8 bolt and cut the head off. Heated it up and bent a candycane hook where the head used to be. Then I just simply hooked the highlift Jack, ran the boat through the factory roll bar hole, and tighten the nylon lock nut on the bottom side to pull the jack down tight so it wouldn’t rattle. The bottom footprint of the highlift Jack slides over a stud that I installeView attachment 86328d at the bottom of the rollbar. This setup has been very secure and has been in use for better than 15 years.

How about some info about that nifty 12 volt plug you have installed in the bed there on the bottom right of this photo!?!?!?
 
How about some info about that nifty 12 volt plug you have installed in the bed there on the bottom right of this photo!?!?!?
I installed that so my kids could charge their electronics. Just a generic 12 volt plug I picked up at an auto parts store. I fit it into the hole on the tailgate bracket. I ran a 10ga wire from an auxiliary fuse box under the hood. Routed the wire under the Jeep along the frame and came up through the body.
 
315612560_10220530364519406_4154133816744234571_n.jpg
 
Back
Top