• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Stuck in park help - auto tranny

barrys

Scrambler Junkie
Lifetime Member
City
East Norriton
State
PA
Went to move my CJ7 for the first time in a over a year. 85 CJ7 all stock, auto tranny column shift. Shift lever was a little hard to move the first time, move Jeep backwards and turned it off. 20 minutes later put it in drive, went 50 feet and put it in park. Went to move it again and the shifter will not move. Feels to me like it is the column vs linkage. Shift lever will move towrds me put will not slide sideways into any gear.
Any ideas what to check?
 
Follow the linkage on the firewall. It may me hung up on a screw head. Silly I know but that was my issue once
 
Nothing looks wrong with it from what i can tell. I followed it to the tranny but exhaust was too hot to tey anything other than looking at it.
 
If there's a a pin holding a rod that connects to the trans (at base of column) try disconnecting the column from the rod. If column shifter now shifts, problem is rod to trans. If column still won't shift, problem is in the column. If I remember correct my 79cj7's automatic had a rod connected to base of column. I'm not familiar with cj8 autos
 
If you disconnect the linkage and still cannot shift the transmission out of park it could be due to this issue as noted by Moses Ludell.

The ‘stuck in Park’ results from a binding valve body shift detent ball. This kit from Sonnax provides a custom sleeve and special diameter ball. The kit requires valve body reaming with the 22771-TL12 Sonnax reamer kit. Sonnax’s custom reamer is well worth the cost.

Here is a link to the original article he wrote about hardening transmissions for Jeeps.

http://www.4wdmechanix.com/Survival-Upgrades-for-Jeep-and-Dodge-Ram-Automatic-Transmissions?r=1


Carl
 
Back
Top