• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Tie Rod and Drag Link + drop pitman

muelleski

CJ-8 Member
City
Middleobro
State
MA
Hi All, new here. I just bought a CJ8 and it has an old man emu 2.5" lift w/ 33's. the tie rod is bent and I notice it does not have a drop pitman arm. I did some research and see some are doing a flip kit. That is a little more than I want to get into but looking for advice if I should go that route or just upgrade to better stuff. This will be a family jeep not much hard core offroading. I am the most interested in tight safe steering. Am I better off just doing the standard upgrade I saw rugged ridge makes and HD tie rod/drag kit and using a drop arm? I think I am also going to add the HD steering bracket as well. Lastly the steering stabilizer is leaking so I will replace that at the same time. Any advice on what others have done would be appreciated.
 
You probably shouldn't need a drop arm for 2.5" Also, if you upgrade to the HD stuff, it is thicker and the mount for the stabilizer won't work... I have flipped and I have not flipped, it is all what you want to do.

some pics: http://certifiablejeep.com/freejeep/freejeep72.php

This shows a 4.5" lift with flipped HD setup with no drop arm... all tucked up nicely.

cb
 
Thanks for your input. So I am pretty much stuck staying with stock replacement if I don't want to do the flip... Ill try and do a little more research later on whats involved with the flip, thanks.
 
As said, you can usually get away with a standard pitman/no flip tie-rod with a 2-3" lift. Personally, I have not used a steering stabilizer for many years and don't miss it at all... I'd just chuck the leaking one and move on.
 
Last edited:
Thanks for everyone's input. I have read you don't need the steering stabilizer so I think I am just going to go with the HD tie rod kit/drag link and put in the HD steering box bracket and hope that takes the awful shimmy away.
 
Your shimmy could also be bad ball joints. If the drag link and tie rod don't fix the issue, I would check that assuming your alignment is good and your tires are all balanced.
 
Also with shimmies and pulling one way or the other, if the ball joints are good, make sure that the preload was set right on them and they are torqued evenly side to side and correctly.
Tire pressure equal on both sides as well.

There are a lot of things that could cause the issues, so checking the easy things first always will put you ahead in the long run.

cb
 
Thanks Ill check that as well. I am sure the wheels/tires are out of balance as well and I will need an alignment after the new tie rod. How do you check preload?
 
Back
Top