• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Timing question

dukhunt

Basic User
City
Louisburg
State
KS
So I have a 1983 with a 258. It has been Nuttered and still has the Carter BDD carburetor. I'm trying to set the timing, but not sure if I am doing it right and I don't want to damage the engine. Here is what I do. First, I warm the engine up to normal operating temp. Then I disconnect the vacuum advance and cap it. I set the idle to 750 rpm, and set the timing to 10 degrees BTC. After that, I reconnect the distributor. Once I reconnect the distributor the idle increases, so i drop it back down to 750 rpm. What scares me is that once I get to this point, if I check the timing, I can't even see the mark. Am I doing something wrong? Thanks.
 
If the vac hose has vacuum to it, it's advancing the timing that's why you don't see the timing mark. Depending on the setup (manifold vac, has vacuum at idle. Ported doesn't have vacuum at idle, but gets vacuum as you give it throttle). Manifold vacuum starts the timing curve before you step on the gas. Ported vacuum starts the curve when you press on the gas. Most guys use manifold vacuum. If the engine pings when accelerating you may need to back the timing down or go to ported vacuum. All depends how it was set up by the guy doing the nutter.
 
I have it connected to the manifold vac, so that makes sense. I guess I will just drive it a see how it goes. Thanks for the info!
 
I set baseline timing with no vacuum advance to the distributor- on my nuttered 258, it's at 10*btdc, and typically runs a little ragged at that point. Once I'm there, though, I reattach the manifold vacuum to the distributor advance, and the rpms come up significantly. I only fine tune the idle screws after that point.

Hoov
 
Back
Top