Where to put the stickers?

[TXJEEP]

I feel like this is a stupid question but I’m looking at my hood (off the Jeep) and I’m trying to figure out where to attach the SCRAMBLER decals. I don’t have any reference to the fenders or the body because they are not on. I could wait for later but it would sure be easier to apply decals with the hood off.

So, my question is, if I want the letters to appear level with the body, can I follow the line of the base of the hood? The hood itself tapers thick to thin from windshield to radiator support. Any suggestions?


?

 

[rubclt]

these are photos of original location for reference, a little sun faded...

 

[TXJEEP]

these are photos of original location for reference, a little sun faded...
View attachment 83120View attachment 83121

Thanks. So it appears to use the lower hood line as a reference.

 

[Scramblin Man]

They did vary from the factory, as typical from AMC.

Attached are photos of my 82 with original decals. About 2 5/8” from bottom of hood. They start 2” from rear of hood.

 

[TXJEEP]

They did vary from the factory, as typical from AMC.

Attached are photos of my 82 with original decals. About 2 5/8” from bottom of hood. They start 2” from rear of hood. View attachment 83122View attachment 83123

That’s great. Thanks.

 

[barrys]

This is an original paint 1981. Picture taken in the mid 90's, 2nd CJ8 I owned (4 cyl auto). Sold it to the guy that is the original reason why I am a Jeep guy know(he had a 350 np435 in his 8 back in the early 90's. He bought it for the 4.10 axles and chevy bell housing automatic. JEEP.COM was his for a short time in the beginning of the internet, he moved on to Unimog's)

 

[TXJEEP]

Worked out pretty good. Have a small crease in the “M”. May replace but I will wait and see how it looks in place. Thanks for the help guys.

 

[jammer1]

Looks great in the picture.

 

[TXJEEP]

Looks great in the picture.

Cheers