• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

ze german intake heater?

WillyT

Scramblered
City
chicagoish
State
IL
This certainly seems like a factory option, but the VW/Audi symbol threw me for a loop. The intake manifold looks like it was cast/machined that way, not an aftermarket deal. Sound about right?

attachment.php

attachment.php

attachment.php
 
I've got a manifold in the garage just like that from a 4.2. Not sure about the VW markings, have to check when I get home...My question is how does the heater hook up to the harness? Is it a permanent connection delio, or does it shut off after the engine warms through the CTO or something?
 
Checked mine, it does not have VW markings. Given AMCs track record of using spare parts, I'm not sure what to make of that. But the heater is factory...and would be a benefit to me of late with the cold weather we've been having. The TBI sure does stutter and waste fuel with a cold manifold.
 
I'll probably keep it. No idea if the Howell injection system would benefit from it, but if it's there, it's there.

This thing probably won't get driven around in the cold. Here, cold = salt on the road.
 
Definite factory gizmo.
The VW version is probably a replacement part that was put in using handy-dandy cross reference numbers.

It is supposed to heat the air/fuel charge as it enters the manifold at low temperature to 1. prevent/reduce condensation inside the manifold while cold and 2. aid in vaporization of the fuel/air charge as it enters cylinder and is compressed.

So it is a polution and efficiency thing. Not required to run, but doesnt hurt either.
 
Audii is one of the worlds biggest holders of patents with respect to aluminum and casting it. They have spent a lot of corporate know how on developing that technology and licensing it to others. I think that they actually make more from that side of the corporate house than the cars.

Anyway I bet that Jeep bought it from them to help with the intake stuff. I imagine that only the heater is Audii.

Any ways it should be hooked up to the choke circuit. There is a temperature sensor on the engine and once it senses enough heat it shuts down power to the choke and that heater I believe. I remember tracing out that circuit when I did the rebuild on a 86 CJ-7. We were trying to figure out what wires to eliminate from the engine bay.

It is nice to have but not required.



Carl
 
Back
Top