Cobound
Legacy Registered User
- City
- Twin Cities
- State
- MN
Not entirely sure what forum to post this in, but thought I'd start in this one, hope it works:
Well, first some history: I purchased this in June of 2009 (like everyone else, having wanted one for YEARS) as an '84 CJ8, half cab, 350, auto, D44f/D60r, 4.56, ARBs, Warn 8k, M.O.R.E. shackle reversal w/ the old buggy leaf setup...gray console and sprayed in liner, tan seats, white body and some black accessories (not color matched at all). It had a set of 35x12.5 BFG ATs and a custom front roll cage.
I purchased it as a Jeep that I could drive daily and hit the trail when I wanted, a dual purpose Jeep. I've had some trail only Jeeps over the years and now w/ kids getting older I wanted something I could get them into and enjoy as well; other than just my wife's JK. Original plans were to upgrade the tires, tie in the cage, install a rear seat and a soft top...wheel it ocassionally and drive the piss out of it. What I found out about it after driving it A LOT and taking it on several wheeling trips, last one was Moab Easter Jeep in '10, after putting some miles and dents in it...
Guy that originally built it, painted it, covered up a bit of rust and, the spray in bedliner was too thick in some places and caused the doors and tailgate to close improperly, and there seems to be some fuel line issues.
The day I bought it -
Immediately swapped the half top for a full soft top, added a rear seat, tossed on some Pitbull Rockers w/ beadlocks and hit Moab 2010-
Got back after the dent incident, wheeled it some more, took out a front drive shaft and the lockers...headed into the next stage - stripping it:
To compensate for future obstacle collisions, added some T&T Customs flat fenders, rockers and rear quarters:
Well, first some history: I purchased this in June of 2009 (like everyone else, having wanted one for YEARS) as an '84 CJ8, half cab, 350, auto, D44f/D60r, 4.56, ARBs, Warn 8k, M.O.R.E. shackle reversal w/ the old buggy leaf setup...gray console and sprayed in liner, tan seats, white body and some black accessories (not color matched at all). It had a set of 35x12.5 BFG ATs and a custom front roll cage.
I purchased it as a Jeep that I could drive daily and hit the trail when I wanted, a dual purpose Jeep. I've had some trail only Jeeps over the years and now w/ kids getting older I wanted something I could get them into and enjoy as well; other than just my wife's JK. Original plans were to upgrade the tires, tie in the cage, install a rear seat and a soft top...wheel it ocassionally and drive the piss out of it. What I found out about it after driving it A LOT and taking it on several wheeling trips, last one was Moab Easter Jeep in '10, after putting some miles and dents in it...
Guy that originally built it, painted it, covered up a bit of rust and, the spray in bedliner was too thick in some places and caused the doors and tailgate to close improperly, and there seems to be some fuel line issues.
The day I bought it -
Immediately swapped the half top for a full soft top, added a rear seat, tossed on some Pitbull Rockers w/ beadlocks and hit Moab 2010-
Got back after the dent incident, wheeled it some more, took out a front drive shaft and the lockers...headed into the next stage - stripping it:
To compensate for future obstacle collisions, added some T&T Customs flat fenders, rockers and rear quarters:
Last edited:




