mysunnshine
Legacy Registered User
- City
- Phoenix
- State
- AZ
Don't waste your time.... Just put the hydroboost on.
Sent from my SM-G920V
Sent from my SM-G920V

Don't waste your time.... Just put the hydroboost on.
Sent from my SM-G920V
He might be thinking safety or he's predicting you'll end up with even more HP eventually. I think the latter. If 400 is good 500 is better.
Only milled the heads .015. Compression Ratio is still less than 10:1On the 243 heads did you mill the heads to get your compression back up because of the larger combustion chambers? Or just put them on as is?
Make my beer fund continually great by buying good used clean low mileage takeout wiper motors from me for $35 [emoji846][emoji482]pile of wiper motors not shown [emoji6]![]()
Well my wiper motor is still going strong after 35 years of work, which is more than can be said for the Crown ball joints, shackles and dont even start me off with the 150 mile tie rod end.....
As i believe zr10054 and Belizeit were trying to say OEM or a proper manufacturer such as MOOG, Federal Mogul,Spicer etc has to be the better choice, its just a shame a lot of the big companies still have their stuff made where labour is cheap and quality isn't always a high priority.
There's always one smart __ in the crowd but it's usually me. LOL It's 24 degrees here and we don't know how to act.We don't use wipers out here in the desert so our motors are like new. 😎
Sent from my SM-G920V