• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

SBC 350.. starting issues

Fish81Scram

New member
City
North Caldwell
State
NJ
So i'm sure as alot of you i have a SBC 350 and lately been having starting issues after i run the engine for a period of time (over 20m).. basically have to add a good deal of gas while starting to get it going.. anyone have any ideas? been thing i can add a spacer to the carb and that might help.. but not sure why.. just something i was recommened.. anyone have any thoughts? or test i can do to narrow down the issue?
 
Carbureted? What kind of carb? Basically long crank after hot soak. Like the fuel in the float bowl is draining back or evaporating.

It’s been so long since I’ve messed with Carb’s. But I’ll give it a shot.
 
So many things. Electric fuel pump eliminates a few. I would try turning the key to activate fuel pump, wait 5 seconds then crank engine to start. See if that cures slow start. If it does you have fuel bowl issues. Choke operation is another item to check, especially if electric.
 
Here are some ideas:
1) Choke - do you have an electric choke and is it stuck closed?
2) Not sure what kind of carb you have but there are TONS of videos about how to tweak carbs on the U-Tubes. Check out Thunderhead289's vids. I'm thinking maybe some debris in the accelerator pump, out of adjustment on the fast idle circuit or maybe a vacuum leak???
3) I have a mechanical pump that hits north of 12psi so I had to put a fuel regulator on to get it down to 7psi. At 12, it would flood the carb when I turned off the engine and would be hard to start. Regulator helped tremendously! With electric pump, do you know what psi it is pushing? Every source I've read and/or spoken to, including Holley tech support, states 7psi is the max you should have to a carb.
 
Back
Top