Search results

I run a GM NV-4500 5-speed transmission with the 6.34:1 first gear. And I run a Napa 73173 Clutch slave cylinder.

Thanks!

@Belizeit My Scrambler was originally a 4-cylinder. This is what I used.

Either my grill support tab is bent down or yours is bent up... :ROFLMAO: How long has your Master Cylinder been installed and has it leaked at all?

Here is my update. I decided to put in the Autozone Duralast version of the clutch master cylinder. The Doorman, O'Reilly and Napa units all look the same with minor variations on the plastic reservoir. Went with the Duralast as it has their "lifetime warranty". So, if it leaks at any...

I have a custom one that I had made 20+ years ago. If I was doing one now, I would look at these two: https://mountainoffroad.com/products/axle-plates-for-our-tb-500-traction-bar-for-rear-axle-for-jeep-cj71976-86-jeep-wrangler-yj-1987-95?variant=44671915262258 That one may not be long enough...

My wife's 2025 2-Door JL Willy's with the V6 and 6-speed has it. It is a stupid "feature" and I'm glad they will be going away soon on new vehicles. We put in this in the first week we owned it: https://www.smartstopstart.com/jeep-dodge-chrysler-products.html I found a discount code on the...

Those tops can be a real pain to get on. You probably already know but just in case: The rear bow is not in the fully extended and locked position in your picture. Here is what mine looks like:

Yeah. Those full Kayline's are hard to get on without heat. Here is my page showing my top going on. It is a great top. I was lucky to get a NOS full top with hardware. It's not new any longer with all the trails I've done. Has pin stripes on the windows, slight hole in the top on the tall...

Here are the instructions for the 1" Daystar body lift I used. They have a diagram showing the positioning: Product page: https://daystarproducts.com/products/daystar-kj04504bk?srsltid=AfmBOopIij5xUEojL1SXC024Z3wiSSRc30uvyLIpS33gTsqD_D951Gn_ Instructions...

Merry Christmas everyone! Thanks Secret Santa! Cool stuff! The hands free headlamp will be awesome!

Update. The Wilwood 260-15098 is a nice unit but the smaller 3/4" bore size is not going to work. I got it installed with a heim joint that I extracted the ball from. Spent a lot of time bleeding it to make sure that was good and then adjusting it at the pedal with the threaded rod and also...

Turned over 10K miles since the rebuild! (with the new speedometer)

Wow! That's amazing and a great job!

Shipped mine out today!

Correct, the below pic shows them how mine came from Painless and they are in the wrong position. I swapped the two circled wires, and it resolved my issue. This shows the proper order. "Bk" on the schematic is really gray on my harness. After I swapped the two wires it is now: Orange...

Good call! Yes! That's for sure. I could never have worked through my project without the historical and current knowledge that this site has.

Damn! I have that disease too! I have a Brady label machine and use it frequently too.

I guess that's better than the "3 P's" Piss Poor Planning... :LOL:

I also posted my gear checklists here: https://www.cj-8.com/threads/georges-checklists.53722/post-474300