• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

4.0L Head Swap - Dead Cylinder

05unlimited

Legacy Registered User
City
Lancaster
State
CA
I had the cam go out on my '81 4.2, so after replacing the cam, chain, gears, and lifters I decided to do a Mopar MPFI conversion along with a 4.0 Head conversion. Now I have a dead cylinder. First it was #5, now 5 is good and #6 is dead. This is what I have checked so far;
Plugs, swapped, checked gap - good, not the problem
New plug wires, has spark - not the problem
Injectors, swapped, new O rings, measured resistance (around 14.7 Ohms), good - not the problem
Computer and wiring to injectors, point-to-point wire check and swapped brain, good - not the problem
Rebuilt 7120 head, leak down test good, preload good - not the problem
New 4.0L pusrods, preload good - not the problem
Dead cylinder switched from 5 to 6 after switching pusrods from the original 4.2 PR's to new 4.0L PR's

Intake manifold along with the fuel rail, injectors, and throttle body came from a 4.0L Wrangler. Sat in my garage for about a year before being installed.

Next steps;
Remove intake and inspect for holes or cracks, or restricted runners
Remove head and inspect gasket for leaks.
4.2L block has the 7/16 studs with the centering sleeves for the 1/2 sized head bolt

Has anyone experienced this before? I am quite baffled by this. Any ideas would be greatly appreciated.

6.jpg
7.jpg
14.jpg
13.jpg
11.jpg
 
Last edited:
I pulled the intake off this weekend and......nuf said. This is what happens when the shop tech answers a cell phone call and forgot what he was doing.
BANANNA IN THE TAILPIPE.jpg

Took the boys out into the desert to the sporting club I am a member of and let them tool around in their Hurricane. Ryan, the 2 year old is driving, and Matt the 4 1/2 year old is pulling (while Ryan is going FWD).
MATT_RYAN_HURRICANE_2.jpg
 
Last edited:
Wowwww. Mail it back to them with that picture.. :banghead:

Sent from my SPH-L900
 
Well, The '81 is all back together, Whoo Hoo! and running strong. I smogged it Friday and passed. The way it sits now:
New stock cam, timing chain, timing gears, lifters, and 4.0L push rods
New Mellings oill pump
New rear main seal
Mopar MPFI
4.0L head
Ford Contour Dual electric fans with a DC controller fan controller
New engine wire harness
4.0L Power Steering pump
New radiator
Custom Full roll cage w/ 3 rows of 3 point seat belt connections
Full carpet
Bestop Trailmax II seats
ACME Full Hard top
'82 Wide Track axles F/R from a 4-cyl "7" Laredo (4-cyl's have 4.11's)
T-5 Trans from the same donor "7"
OE Chrome Wagon wheels w/BFG 32 X 11.5 X 15 tires
BDS 4" LIFT w/ Wrangler spring conversion in front
20 gallon fuel tank w/MTS CJ-8 hoses

Why park on asphalt when you can park in the dirt
reborn 81.jpg
 
Back
Top