05unlimited
Legacy Registered User
- City
- Lancaster
- State
- CA
I had the cam go out on my '81 4.2, so after replacing the cam, chain, gears, and lifters I decided to do a Mopar MPFI conversion along with a 4.0 Head conversion. Now I have a dead cylinder. First it was #5, now 5 is good and #6 is dead. This is what I have checked so far;
Plugs, swapped, checked gap - good, not the problem
New plug wires, has spark - not the problem
Injectors, swapped, new O rings, measured resistance (around 14.7 Ohms), good - not the problem
Computer and wiring to injectors, point-to-point wire check and swapped brain, good - not the problem
Rebuilt 7120 head, leak down test good, preload good - not the problem
New 4.0L pusrods, preload good - not the problem
Dead cylinder switched from 5 to 6 after switching pusrods from the original 4.2 PR's to new 4.0L PR's
Intake manifold along with the fuel rail, injectors, and throttle body came from a 4.0L Wrangler. Sat in my garage for about a year before being installed.
Next steps;
Remove intake and inspect for holes or cracks, or restricted runners
Remove head and inspect gasket for leaks.
4.2L block has the 7/16 studs with the centering sleeves for the 1/2 sized head bolt
Has anyone experienced this before? I am quite baffled by this. Any ideas would be greatly appreciated.





Plugs, swapped, checked gap - good, not the problem
New plug wires, has spark - not the problem
Injectors, swapped, new O rings, measured resistance (around 14.7 Ohms), good - not the problem
Computer and wiring to injectors, point-to-point wire check and swapped brain, good - not the problem
Rebuilt 7120 head, leak down test good, preload good - not the problem
New 4.0L pusrods, preload good - not the problem
Dead cylinder switched from 5 to 6 after switching pusrods from the original 4.2 PR's to new 4.0L PR's
Intake manifold along with the fuel rail, injectors, and throttle body came from a 4.0L Wrangler. Sat in my garage for about a year before being installed.
Next steps;
Remove intake and inspect for holes or cracks, or restricted runners
Remove head and inspect gasket for leaks.
4.2L block has the 7/16 studs with the centering sleeves for the 1/2 sized head bolt
Has anyone experienced this before? I am quite baffled by this. Any ideas would be greatly appreciated.





Last edited:




