• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

ACME Full Length Hard Top Clamps

05unlimited

Legacy Registered User
City
Lancaster
State
CA
I have a question about the clamps that mount the ACME full length hard top to the "8" (I have new correct locking clamps). Is there some sort of backing buried in the fiberglass that the screws/pop rivets anchor to? Or are you just screwing/drilling into fiberglass? I haven't tried a magnet yet, just thought of this today. If the anchor is made of aluminium, a magnet wouldn't work.

Thanks in advance.
 
I checked mine, it has a steel (magnetic) of some sort buried in the fiberglass. Mine has aluminum rivets holding the clamps on. But they are very loose and the clamps a rusted. Where did you find new ones?
 
I bought them from McMaster Carr online. They are the exact same latches used by Acme. Part number is 1864A15 at: McMastercarr.com
 
Yeah, I used a rare earth magnet (super strong) to verify that there is a steel plate imbedded in the fiberglass behind each clip. The plate looks to be about 2" square. Good news. Has anyone had to repair the cracks that show up in the top corners of the rear hatch? Also the rear seals (large D shaped with 3 or 4 fingers and a smaller one) can be ordered from any good RV repair shop, take in a sample for comparison. Here are a couple of link:
http://www.trimlok.com/prod/D-Profi...tegories_145/2828-Series-Rubber-Seal_127.aspx
 
Last edited:
Back
Top