- City
- Claflin
- State
- KS
Long story short, I am finally putting my 401 together after years of gathering parts and putting off the assembly. I started to assemble the engine and found out one of the camshaft bearings was not installed perfectly, causing the camshaft to not fully seat in the engine (tried my Engle and original cam, same result with both). This resulted in me having to take the crankshaft and piston/rods back out. Somehow in the process, idiot me knocked one of my custom Bulltear pistons off of my work bench onto the concrete floor below. This caused some slight pitting and rough spots on the top edge of the piston. I have only built a few engines so I was hoping someone with more experience or has come across something like this can help me shed some light on what to do next. There are a few other small imperfections (pits, etc) I'm assuming from casting/forging/valve relief cutting on the pistons so I was how big of a deal these pits and rough spots wound be?
Can I simply grind/polish the rough spots out, not worry about the slight pits, and run the piston with no adverse affects? Do I need to just order a whole new piston from Bulltear? I'm still pissed at myself for this...
Sent via signal flare
Can I simply grind/polish the rough spots out, not worry about the slight pits, and run the piston with no adverse affects? Do I need to just order a whole new piston from Bulltear? I'm still pissed at myself for this...
Sent via signal flare
Last edited:
