• Notice for iPhone users: DO NOT use the image size reduction option when uploading photos to the forum. This causes portrait images to post as landscape. We have added a warning to the image insert pop-up as well.

Anti-seize on U-joint bearings caps?!

MomoJeep

Basic User
City
Seattle
State
WA
I bet this will be controversial!

I just took a U-joint out of the front axle shaft. There are no bearing cap straps. They've been in there for more than 20 years! It took a torch, a lead hammer, etc, etc. to get them out. A real PITA. I want to put the new ones in with a little bit of anti-seize on them. Any reason why I should not?

PS - I started using Anti-seize on exhaust bolts, lug nuts on my boat trailer (salt water), etc. So far so good! It's so much nicer for disassembly..!
 
Interesting. I know the axle shaft joints are notoriously tight, but they have to be that way because of the forces they are subjected to while turning under load. I don’t know if anti-seize would help or hurt.
 
Interesting. I know the axle shaft joints are notoriously tight, but they have to be that way because of the forces they are subjected to while turning under load. I don’t know if anti-seize would help or hurt.

Good point. It could be argued that the caps could be more likely to "move", but I would think the c-clips keep them properly located anyway...(?)
 
Would keep them in place, wouldn't really keep the caps from spinning in the yoke. Only thing that should spin or move is the bearings. I would think most bearings would freeze up before the cap rusted to the yoke.
 
Back
Top